radius tip

A model is developed for the calculation of the initial rotor tip vortex core radius aiming at eliminating the empirical parameters of the tip vortex in rotor free-vortex wake analysis.

建立了一个旋翼桨尖涡初始涡核半径计算模型，用于消除旋翼自由尾迹分析中桨尖涡涡核半径依靠经验设定的现状。

互联网摘选

The line width of nanostructures is influenced by many factors such as tip curvature radius, detained time in the base surface, scanning speed, humidity, surface roughness etc.

尖端曲率半径、针尖在基底表面滞留时间、针尖扫描速度、空气湿度、表面粗糙度等均会影响纳米结构的线宽。

互联网摘选

Compensating of tip radius is a key problem in CMM. It has a great influence to its measuring accuracy.

测头半径补偿问题是三坐标机测量中的一个关键问题，影响着三坐标机的测量精度。

互联网摘选

Hence, jet tip velocity produced by direct annular initiation is higher than that of plane initiation, and plane initiation higher than point initiation. It is also concluded that the jet tip velocity of plane and annular initiation increases as the initiation radius increases.

环形起爆形成的射流头部速度高于面起爆的，面起爆高于点起爆的，并且随着起爆直径的增大，面起爆与环形起爆所形成的射流头部速度逐渐增大。

互联网摘选

By means of SiO 2 mask and SF 6 etching corrosive, the cantilever beam with tip is shaped by reactive ion etching once through operation. The probe has been shaped by wet corrosive and the tip radius is about 50 nm.

以SiO2为掩模，SF6刻蚀硅，用RIE与各向同性湿法化学腐蚀相结合使悬臂梁探针一次成形和用湿法腐蚀锐化探针，针尖半径约50nm。

互联网摘选

The dimensionless tip velocity increases and the tip radius decreases with the increase of anisotropy.

随着各向异性的增加，枝晶尖端生长速度增加，尖端半径减小；

互联网摘选

Determined are the applicable velocity ranges of various models for steady growth of dendrite, the tip radius of which agrees well with experiments.

在此基础上，给出了各种稳态约束枝晶生长模型的适用速率范围，并与实验结果进行了比较。

互联网摘选

To provide a theoretical basis for the conical stylus cone angle selection. ( 2) Analysis of the stylus tip radius and the stylus static pressure causing timber roughness parameter measurement error, calculation of the roughness measurement error value caused by the different tip radius.

分析触针针尖圆角半径和触针静压力引起的木材粗糙度测量误差，计算不同针尖半径造成的粗糙度测量误差值。

互联网摘选

According to the analysis on the carbon imprints of electrode tips, three parameters were defined to represent the tip surface characteristics: relative radius ( Rr), edge concentration ( EC) and eccentricity ( ECC).

基于对电极压印的分析，定义了3种电极头表面特征参数：相对半径（Rr）、边缘聚集度（EC）和偏心度（ECC）。

互联网摘选

All rigid projectiles shall have a tip radius of not less than2mm.

所有刚性射弹物不能有半径小于2毫米的尖头。

互联网摘选